Coolerguys Comcool (4) Fan Component Cooling Stand Kit with Manual Variable Controller and Power Supply Model: CCS 120-4M
840556100577
This all metal (4) Fan 120mm cooling kit creates a wave of air to gently cool tough heat problem areas. It is the perfect fit to lie between, on top of, or below any media component that generates excessive heat.
The Comcool (4) Fan Stand is all metal and black powder coated to match virtually any black component in your setup. With its (4) 120mm fans it pushes up to 184 CFM which is enough to cool even the largest receivers. Even with all that air the noise is limited to 26.4 dB at full speed.
Stand Dimensions: 407 (~16") x 305 (~12 ") x 45mm (~1.75") (W,D,H)
Contents: The kit comes with stand, fans, power supply, grills, variable controller, power hub, 4pin extension, nuts bolts and tie down.
(1) Comcool (4) 120mm all metal stand
(4) Coolerguys Ultra Quiet 120mm dual ball bearing fan
(4) 120mm Black Fan Grill / Guard
(1) 12v Power Supply with 4 Pin Molex 2A
(2) Nylon multi-purpose ties/ Black 4" with anchors
(4) Nut and Bolt Black 35mm set of (4)
(1) Manual 12V DC Variable Speed controller
(1) 4port Fan Adapter
Fan Specifications / per fan:
Model: CG12025L12B2-3Y
Dimensions: 120x120x25mm
Rated Voltage: 12 Volts
Operation Voltage: 6.5~13.8 Volts
Input current: 0.30 Amp Max
Operation temperature: -10 to +65 C
Storage temperature: -40 to +70 C
Bearing: Dual Ball
RPM: 1200 +/- 10% with adapter
CFM: 46 / per fan
dB: 20.4
Installation: Install fans and grills in metal stand using nuts and bolts. Fan side up determines direction of air flow through stand. Grills are installed on the top of stand with concave side up to prevent from pressing on fan. Bolts are installed through grill, stand then fan with nuts screwed on the inside bottom of fan frame. Metal stand has half-moon cutout for power cord exit. Place fan hub inside stand above cutout using Velcro adhesive strip. Place fans on stand so power wires are close to hub. Plug fans into 3pin extensions on hub. Plug 4pin extension into 4pin power input on hub and plug speed controller into other end of extension. Plug other ends of speed controller into power supply 4pin Molex.
With this kit, you can reliably cool your components for years without adding a lot of noise to your setup.
This is a Kit and some assembly is required.
We trust in our products at Coolerguys and test everything that is sent out! We happily extend a three-year replacement warranty to all our Coolerguys branded products.
